Your cart is empty.
Your cart is empty.Product Description
Package Included: 1 x Stepper Motor
Specification:
CD-ROM Driver Stepper motor with screw slide, Two-phase four-wire stepper motor
Motor Type: 2-phase 4-wire
Drive Voltage: 5V-12V/ 100-300mA
Stage Total Size: 81.5x25X20mm/ 3.2" x0.98" x0.78" (including motor)
Sliding Block Size: 25x10x14mm/0.98"x0.39"x0.55"
Motor Diameter: 15mm/ 0.59"
Motor Length: 11mm/ 0.43"
Step Angle: 18 degrees (20 pulses per revolution)
Lead Screws Length: 60mm/ 2.36"
Lead Screws diameter: 3mm/ 0.11"
Effective Slide Stroke: 48mm/ 1.89"
Screw Pitch: 3mm/ 0.11" (3mm per revolution)
The fastest moving speed: about 200mm / min
Wiring: Yellow A+, White A-, Red B+, Black B-
Tips: The stepper motor direct power is not rotating, it need to stepper motor driver board. please search B09BTWQPTB.
Note that:
1. The motor used in this mobile slide is an old motor, and the products are shipped after testing.
2. The sliding table is a bit noisy when moving at low speed, please pay attention before buying.
bpauly5
2025-02-18 18:26:40
This actuator/stepper is great for testing your circuitry and code, but don't expect to move anything with it. Very low motor torque and the carriage will bottom out on the mounting screws with any load on it.However, it's an inexpensive device for prototyping and development - perfect for STEM demonstrations of microelectronics!
ZAP
2025-02-10 17:02:27
Description says 5v, but in listing description says it can run 5-12v. 12v certainly worked, but after a few cycles of moving a step and back, the motor was so hot that i must have been close to melting the plastic of the linear actuator housing. Have to remove a few stars for describing 12v power when that would certainly lead to smoke, fire, destroyed motor or some other
J. Wang
2025-02-06 11:21:07
Just not good quality. Need it for a project. It breaks after a few trails. Need to buy another one….from difference place. I do not recommend this one.
Recommended Products