Your cart is empty.
Your cart is empty.Lightweight die-cast aluminum housing design for durability; anti-jam magazine prevents jams and misfires; heavy-duty stapling mechanism for durability; surface guard to prevent damage to underlayment material; ergonomic design is weighted forward for comfortable use; uses Dewalt Heavy Duty Staples series DWHTTH700 available sizes 5/16" (8mm), 3/8" (10mm) and 1/2" (12mm), also uses same range of Stanley TRA700 series Heavy Duty Staples plus Arrow T-50 Heavy Duty Staples.
johnnyt2
August 6, 2025
This is a nice hammer tacker. It sinks 1/2-inch staples flush to the surface. I wish it could accept slightly longer staples but 1/2-inch is the max. Durability is yet to be discovered since it's brand new now. The picture shows "often purchased together" and showsBostitch Office SB351/2-5M that do not fit this hammer stapler. Make sure you get T-50 that are 1/2" or shorter. This feels like a quality tool.
Ben moncivais
July 31, 2025
Work at a mill as a wrapper, this works better and easier to load than others.
NJA
May 30, 2025
The tool works, no doubt about it. I just used it to insulate an exterior wall and tacked it in no time. It’s a little heavier than my fathers hammer tacker, I don’t recall which brand, but that was much lighter than this tool, that’s my only knock. However, I’m writing this review to not trust Amazon’s recommendation to purchase the BOSTICH staples along with the tool because the staples don’t fit the tool. I should have checked, it’s my fault but I trusted Amazon advertising compatible supplies. Amazon did refund, so that was good but I had to go out and buy staples, which was a real time waster. It’s a well made, quality tool, using the right staples of course..
Marisol Lopez
May 22, 2025
Me a funcionado muy bien
Jimmy Riddle
May 16, 2025
Heavy duty work great for stapleing down carpet pad , and it's nice and light
Maxine
April 19, 2025
I had to hang some vapor barrier in my basement so I figured I would spend the few extra dollars and get the hammer style stapler vs hand one. Boy was I glad I did! Hanging the plastic took half the time it would have other wise. Within seconds I was able to go down the line and shoot in my staples. It was so easyand dare I say a little addictive. I ended up going way overboard with the amount of staples. Besides being quicker it is also more ergonomic - a normal staple gun requires a good amount of squeeze to shoot. This takes a rather light swing. The only downside is you can't be too precise with location.
cdavis
April 16, 2025
Heavier than expected but works fine. Doesn’t drive staples fully in unless if you slam it hard. Flip the tool and you’ve got a hammer to drive the staples fully in if needed.
Osiel Rodriguez
April 6, 2025
Excelente
Customer
April 4, 2025
Good capacity and reliable. A little expensive but does the job
patrick
April 3, 2025
Work really well. No complaints at all.
Kindle Customer
March 27, 2025
Brilliant stapler, I have a sharpshooter but the dewalt is brilliant, no need to hit hard..
pierre
March 13, 2025
j'ai adoré me servir de cet outil pour plastifier les plafonds et murs de la maison. la job est fini, mais l'outil aussi!. j'aurais aimer le garder plus longtemps mais avec l'usage intensif que j'en ai fait, je ne peut pas trop m'en plaindre.
Christine smythe
December 27, 2024
Great
Recommended Products
$101.26
$ 44 .99 $44.99