Your cart is empty.
Your cart is empty.Stlcoug
2025-09-05 21:22:26
Here is what worked for me:I need to replace the outer boots so I kept the axles on the carKey: keep you hands grease free!1) Position the axle so that you can put force on it and the axle won't move. This keeps you from getting injured.2) Take the boot and turn it inside out3) Spray inside the boot with cooking spray. Do NOT spray the outside of the boot or your hands. Set it down on a clean surface.4) With your hand inside the cone spray the outside of the cone with the cooking spray.5) With dry clean rag place the cone on the axle6) With your clean dry hands push the boot over the cone. If your hands are not clean and dry use a dry shop towel around the boot.7) Once the boot is over the cone. Remove the cone.8) Reverse the cv boot by pushing it inside out. Keep in mind that the narrow portion needs to be out all way even though it may not look that way.
Larry Lecave
2025-07-23 17:55:14
I have installed many cv boots from a lot of other suppliers over 30 years as a mechanic this one was the easiest & fastest I will purchase more only from them
Pappy
2025-06-23 13:41:21
Arrived just as described. Installation was as expected. Durability, time will tell.
Garrett
2025-06-02 16:20:43
I was expecting to be a pain to put these on but with a lil wd40 it made it really easy. The also seem to be a different matterial than stoch gm but they otherwise have held up well, had them on for a few months and they dont seem to be any different than when i put them on
UNCFAN
2025-05-20 15:22:01
Boots seem to be sturdy; however, I could not get them to stretch over the cone to use on the cv joint.
Julián
2025-05-08 18:11:30
Para mi camioneta una troca Ram sport 2015 1500
Hatim Tilib
2025-04-21 18:25:50
it's hard to push it in but its doable. provided cone too large you can cut it to your size it will make easy-to-use
charles
2025-03-29 14:01:25
I put furniture polish on the cone or funnel to slip the boot over to put it on the CV axle the furniture polish worked better than anything to accomplish this and it was not easy but it did work. I ended up cutting my calm down so that it would not have to stretch as much over the end so that it would fit on the end of my CV joint better once I got it on I took the clamps and use angle cutting pliers after I snug the clamps down as tight as I can get them with my hand and cramped it or that it would not come back loose I was careful not to cut the clamp. This was the best option for me. If you don't want to use the funnel then you could try to knock the snap ring loose off the end of the CV joint you can YouTube this but unfortunately one of mine would not break loose.
pierre
2025-03-05 15:32:22
As advertised
Maddy
2025-02-27 18:42:37
The media could not be loaded.
cm
2025-02-14 21:52:00
the cone is garbage broke first use
Recommended Products
$26.30
$ 13 .99 $13.99