Your cart is empty.
Your cart is empty.Features: Made from high speed steel, these reamer cutters have high hardness.High-speed steel tool is good for general purpose applications, with combination of hardness and toughness for wear resistance Sharp cutting-edge, high cutting ability, high accuracy, long service life. Applicable for reaming to mold processing and handicraft processing. Widely used for bore machining, installed in drilling machine, milling machine, etc.Can be used with a wide variety of tool holding systems. Reamers are used for light cut, repair work, removing stock or simply for enlarging holes Processed surface of iron, plastic, wood, copper, aluminum and other soft materials.Designed for accurate reaming in most materials, using all types of equipment including screw machines, turret lathes, drill presses and machining centers.
Payne
2025-08-24 17:21:46
I bought this for one task and it work perfect.
Steven
2025-07-24 09:44:19
Very good quality
j
2025-07-21 14:33:44
It is a cheap reamer, and it is labeled as HSS on the shank… Which is a different material than tungsten carbide as listed in the top description. That part was my fault, as it does say HSS in the full description.However, one of them is somehow cut eccentrically on the shank as pictured. So it wobbles like crazy in a chuck. That’s a manufacturing defect. I ordered two and the other one is a bit better, but I would recommend spending a bit more and getting a tool that is made well or at least quality controlled.
Customer
2025-05-06 18:39:50
The shank runs out .025 to the flutes! It's bent! the lead/ chamfer is 3 times the proper length. And to boot!! The driver ran over my flower bed! This is the worst yet.
Bob G
2025-01-29 10:59:30
The 1/2" reamer reamed to .512" instead of .500". Upon closer inspection of the reamer it became obvious that one cutting edge was not ground to a taper, just comes straight out and that's enough to pull it to one side as it goes in cutting. Unusable.
Recommended Products
$30.17
$ 12 .99 $12.99