Your cart is empty.
Your cart is empty.Customer
2025-08-22 10:32:24
Work great , good deal
daddyurbs
2025-07-22 13:54:18
Thus receiver is amazing ,elrs is so easy to use, and I like how there are 2 different length antennas.
DJ Triple9
2025-07-19 13:20:02
It tiny, and even comes with the heat shrink tube. Long and short antenna included which is nice. Elrs firmware was easy to update. Great price for what it is.
Adam G.
2025-06-18 21:05:31
I never had issues with ELRS until this RX. I’d recommend going with the EP1 instead. I had complete rx loss and failsafed in parking lot. I don’t know why I thought I’d trust an HGLRC rx as I’ve never trusted any of their other products.I bought another one of these just for the antenna with no intent on using the Rx, but the ended up needing one. I flashed firmware back to 2.5.2 then to the latest I tried turning model match on and off, reset the module match number, made sure mode match is off in the radio as all my RP1s don’t use it. I even tried swapping rx and tx wired just in case it was mislabeled. No matter what, no inputs to the rx. It binds to my controller but does nothing. It’s cheap because you’re only buying antennas, the Rx doesn’t work.
Charles Adams
2025-05-23 17:46:50
Great value product, only complaint is it's easy to disconnect the plug (even when padded between two layers of Alien Tape) so you may want to direct solder these on both ends.The size is absolutely tiny, like it'd fit on the tip of my pinky. If I needed a ELRS receiver in my hand it would be this one. Probably be great for a tiny whoop setup IMO, though I'm not sure about the weight.Nice that it comes with 2 dipole antennas. One short one longer.QQ...The colors in the wiring diagram do not match the plug you get so make sure you wire it up correctly. The wires are yellow white red and black, only the red and black correspond to the diagram in the manual. I inadvertently thought the yellow would match the diagram also, but it's deceiving and does not. The yellow is green in the diagram and the white is yellow in the diagram as seen in photos.I guess it's too much to ask to have matching colors to the diagram. After all, FPV gear makes everything harder.
Woodsman
2025-04-08 13:33:38
I have a couple of these and they work great. They are just a touch bigger than a HappyModel version but not significantly. The price blows all the other EP1 style ELRS receivers away.
Conrad Mountjoy
2025-02-02 17:08:41
Bound up real quick and easy. Great range and very very small so easy to put anywhere in rc craft. I us it on my quadcopter, and it's great. Flown over a football field and more with no break up. Probably not even any where close to its limits. Sad to see it almost double in price for greed.
Jaime homar jr
2024-11-26 10:53:02
Works well and easy to install, if you need it for a Pixhawk 6x maybe you will need to find another wire with the same input as your Pixhawk and just weld both wires, it works for me.
Recommended Products
