Your cart is empty.
Your cart is empty.Product Description
- Normally Open with 80 Ohms Coil Resistance
- The size of the round stud terminals: M6/6mm
- Nominal coil voltage: 12VDC
- Pickup voltage: 8VDC
- Dropout voltage: 1.2VDC
- Maximum applied voltage: 14VDC
TERMINALS
- 85 Coil, Ground
- 86 Coil, Trigger
- 87 Normally Open (N/O)
- 30 Common connections to NO & NC terminals
Dave
2025-08-23 11:12:55
It’s perfect!Bought this for my sxs to control a secondary fuse block I put in for accessory lights/radio ect.I used a different brand the first time and it was all metal. It would get pretty hot and lasted about 3 months.This one works flawlessly, no heat and has been installed for almost 2 years!
Jeff W
2025-08-16 13:08:50
I used this as an isolation relay for the amp in my truck. Worked perfectly. After about an hour of use the relay was still cool to the touch. Seeing as this relay is rated at 200 amps and the amp is on a 30 amp circuit, I don't foresee any issues with it down the road.
faybbs
2025-07-17 15:02:27
100-Watt 150 Ohm 5% work as breeder slow discharge capacitors150A Single-Phase Diode Bridge Rectifier 150A Amp Power 1600Vconnect from AC side add additional 25amp rectifier bridge from 28vac convert to 28 VDCno capacitor is connected. (capacitors hold the charge constant voltage)DC 8V-40V to 12V 3A 36W, Boost Converter Voltage RegulatorRelay 200A, 12V Continuous Duty Relay, 4 Pin Starter Relay, Spst High Current High Power On/Off Control Relay, Split Charge Relay Switch cut off on voltage to torchit may be too much work, but it prevents from accidental discharge at torch or tip
Keith568
2025-07-08 14:05:22
Been looking a long time for a good relay for electric cooling fan swap for my car. Most that I tried would melt the spade terminals . Not this one it's a high quality relay . Been doing great under the hood.
c
2025-07-03 12:32:46
great relay for automotive use, adding accessories to your favorite classic car or stereo system
Placeholder
2025-05-20 10:22:55
Excellent old school quality. I highly recommend it.I used it to replace two 100 amp solid state relays which over heated badly. Mounted on an aluminum heatsink with a power fan.Fed by 10 large 17 volt solar panels in AZ
Jason
2025-05-12 15:58:06
I used this to replace the starter relay on my rough terrain fork lift. It's stored outdoors and would fail frequently. This sealed relay was the answer. Works great.
Spike
2025-04-13 15:07:06
I've used 2 of these now. One was on a gate opener project and the other for an aftermarket onboard air compressor for off-roading. No issues.
Customer
2025-02-08 11:45:20
Awesome. As advertised. Good buy
Michael Frymus
2025-01-07 10:43:03
I have a custom setup in my car and I wanted all my relays to have a master on/off switch, and had no idea how to do it. I came across this big relay, and it solved the problem! I have 6 relays connected through this master relay.It does make a click sound when you turn it on/off, but it happens ones, and its not a big deal. But, just referencing it as smaller relays don't make this sound.
Denis Barrette
2025-01-05 15:33:57
Thank you the unit work perfectly now I don’t have the problem I use to have thank you
Recommended Products