Your cart is empty.
Your cart is empty.IRON AMERICAN
mastershake
2025-08-17 15:06:44
I was disappointed that 2 of the screws sheared, though I drilled pilot holes. Also, I personally don't like the anchors they included because they often fall into the wall or don't bite.I contacted the seller, who responded quickly then kindly replaced them, quickly. Thank you!These are strong and get the job done.Recommend!
J.S.
2025-07-11 11:26:13
This helped clear up some square footage on my home gym. I read a couple of reviews and went ahead and tried it out.Firstly, I have a Bolt fitness sniper bench which weighs about 85 lbs or so. I personally thought this was too heavy for these but I stood corrected. It can probably hold another 20 pounds with easy honestly.Quality: out of the box they seemed a little too thin for my liking. Again I judged too soon but that was my opinion. The hardware provided definitely didn't give any reassurance. You're given one screw per bracket but I went ahead and used an extra 3" exterior screw on each bracket. May not have needed it but it made me feel better.Assembly: if you can find a stud and drill a screw then you're qualified to do so. I used a level just because i wanted it to be precise.I was able to place both of the brackets to where each was supported by a stud, luckily. I'm sure it can be used for a variety of items but as for me, it worked just fine to hang my bench on. The measurements provided are accurate so I would measure what you intend on utilizing these for.
Fr. Ryan Humphries
2025-07-09 18:56:05
I've been outfitting the garage-gym and these brackets are a great space saver. Surprisingly strong and easy to mount with basically any 3/8"-1/2" masonry anchor.
Eric
2025-06-25 12:49:57
Works as intended for a bench. Easy install
dAve
2025-04-28 19:14:20
Walk away from this product and company. I almost lost a finger installing this, and had my drill gone about 1/8 of inch in the other direction, this company would have had one hell of a lawsuit. Why? Because this product does not come with installation instructions - only a QR code pointing to an online video that isn't any help. Specifically, if you tell your customers to "drill a pilot hole," you better tell them what length and bore size to use. Especially if you're drilling into a stud (which for a load bearing product like this, you usually are), a pilot hole that's too small and/or too short will result in a mounting screw that's stuck halfway in your wall. Too far out to keep the wall bracket in place, but too jammed in for you to screw it in using hand or power tools. The result if you're using a power tool: Having to use more torque, the power tool's screwdriver bit not catching the mounting screw, and the power screwdriver spinning right off the mounting screw and towards your other hand/fingers which you were using to hold the bracket level.Again, this company came about 1/8" away from a lawsuit.
JJ
2025-02-28 12:43:14
I ordered to try to use with a dip bar, they ended up being 1/4 inch too short to hold properly so I returned, however they are sturdy construction and if used for the bench as they are made would be a great product.
Kevin
2025-02-08 14:21:25
It took just a few minutes to install. I discarded the included drywall anchors in lieu of using the wall studs. I’m very satisfied with this purchase.
Jarrod Leis
2025-01-25 17:43:20
great for hanging specialty bars that don't fit in traditional barbell holders, hangs my titan multigrip camber bar perfectly on the wall.
steigy72
2025-01-19 12:43:11
Purchased two sets and have now both benches hung.Great option for home gyms owners looking to increase their floor space.
Recommended Products
$69.99
$ 28 .99 $28.99