Your cart is empty.
Your cart is empty. Wavelength :650nm
Power output: 5mW
Laser Shape:Line
Operating Voltage:DC3V-5V
Operating Current: Operating temperature: 0 - 30 °C
Size:9mm(D)*22(L) mm
Packing:2X red Line laser modules
Sam “Monsterâ€
2025-08-17 11:03:45
Really good light. Great for my use
topcat_collins
2025-08-07 12:03:55
New laser pointer much much brighter than the old one - now I can see the line !And a lot cheaper than buying a 'genuine' complete module (which are now obsolete, so are hard to find anyway).
D. Bishop
2025-06-28 16:13:34
Ordered two of them so I could use them in the places I needed. One has a thin enough line to use. The other one has a smeared double line about 3/16 inch wide.I haven't run them enough to see if the bad quality of the line indicates a poor lifetime or not.I expect to buy a replacement soon. It will not be this type. These are poor quality.
Tim
2025-06-06 10:33:54
Purchased for laser alignment but line too short and too thick to work.
Shayne Rice
2025-05-22 17:20:15
I purchased these so I could have a line for my chop saw, the first one initially was great until I turned my saw on and the diode inside rotated off verticle, at first I thought I had it not tight in the clamp I purchased with these. It was tight and I had no way to secure it. I replaced it with the spare I got and that worked fine, however the laser line was much thicker, more than the kerf of my blade (3.2mm). I did read reviews regarding the differences between each one particularly the thickness of the line. It has worked well eventually for my purpose, knowing what I know now I would order 4 because they are cheap. Lining my scripted mark up to the line is easy now. I'm happy.
Robert George
2025-01-15 17:17:56
The laser project is far from perfect but they are very easy to use. The projected line curves a bit at the ends but the middle of the projection is great. Don't use them to land a ship on another planet but they're fine DIY projects.
Michigan Chair CO.
2025-01-09 12:14:46
We use these on our industrial saws to line blades with cuts. Work well
Customer
2024-11-19 15:30:38
These DO NOT PROJECT STRAIGHT LINES. They are curved slightly. At a short enough distance it probably wouldn't matter, but at a few feet it becomes a real problem. I bought these for a novel DIY car alignment project I was working on and mounted them in my garage with a handful of 3d printed parts and chalk lines layed out on the floor. After several hours of minor adjustments I could not figure out why I was unable to project parallel planes until I realized the beams are curved slightly! They are also pretty dim and are not really visible unless you turn the lights off. Overall I'm very disappointed having spent a decent bit of energy on this project only to have poor quality optics be the reason it flopped. Curvature at 8-10ft distance is approx. 1/8" per 4ft of projected line
Recommended Products
