Your cart is empty.
Your cart is empty.Tethered control float switch provides automatic control of a pump in water and sewage effluent applications. For use with Little Giant GP Grider Series Control panels and alarms.
Daniel Smith
2025-08-23 11:42:15
Replaced a worn out septic alarm float with this one. This is a two wire style type alarm (I believe there are 3 wire styles also, but this one has two wires.) It comes with a large worm gear type hose clamp, which I did not need to use. I tested this float by hooking it up directly to the alarm on the side of my house before I opened up the septic tank and replaced it. Just to make sure the float was the issue and that this style is the correct one. Seems to be built well and hopefully get a lot of years out of it.
R.J.B.
2025-08-14 18:17:03
Good value and met the need at hand. Simple to install and easy to verify operation.
Banksta4
2025-07-09 12:19:12
Had a bad float in my septic aerator tank. Easy replacement. Works great when wired and test it in up position.
Robert Schneider
2025-05-13 18:59:52
Easy to install and the 20 foot cord came in handy.
Bobby
2025-04-20 15:01:07
Installed on aerobic septic Little Gaint pump. Easy to install with good instructions. Bracket included for mounting float. Competitive costs.
paul c
2025-03-27 16:34:01
quality float switch that works perfectly in my effluent pump station for the alarm circuit. would buy again.
Sean D.
2025-03-23 14:57:13
Easy install on septic pump. Works as intended.
Thomas Trottier
2024-12-25 14:09:04
This switch should only be used to signal an alarm. It should not be used to run pump amperage through it. I used mine for a high water alarm.
Recommended Products
