Your cart is empty.
Your cart is empty.Product Description
S. Smith
2025-06-17 17:26:55
The tool I received had decent welds, not perfect, but it in no way impacted the use of the tool. I put more force than was needed into the operation just to be sure it wouldn't bend or break, and it passed the test no problem. This is a much better and safer way to pry on control arms than using a conventional bar. I like it, and would buy another if I lost mine.
Ember Blue
2025-03-24 10:21:02
The tool does what it says, but out of the box, the 2 welded arms were crooked. This doesn't affect performance but does say a lot about quality control. The ½ breaker bar holes fit very well on my tool with no slippage. Would recommend having around if control arms are your thing at work.
TravisM
2025-02-04 15:12:47
This is one of those single purpose tools that I used to be against buying. But I also used to work so hard to complete what should have been a simple repair.This is so convenient to realign ball joints and help pop the control arm into position. I think for the cost and time saved even if used infrequently, it is worth having!The construction feels solid. The 1/2 drive holes a little loose but not concerning at all. The detrwnt ball in my square drive doesn't quite hold it in place loose. Finish is nice and surprisingly durable.
Incognito DIY'er/Techie
2025-01-19 14:29:54
The welding on the rods is kind of messy (they could have been ground down for a nicer look), but seems to still hold the rods on the arm well enough to create the torque needed for moving the control arm. Little bit tight in the 1/2" drive cutouts, but with time and wear, can go in smoother I would think. Metal is not the highest quality, but it can get the job done. Overall, does what's necessary.. just not a very polished product overall.
Jay Stone
2024-11-28 12:32:06
This Lower Control Arm Prying Tool, Suspension Specialty Arm Lever Bushing Tool, Lower Ball Joint Pry, Control Arm Tool Suspension Arm Lever Compatible with 1/2" Drive Extension Breaker Bar is nice.This is a nice Lower Control Arm Prying Tool. This is a Compatible with 1/2" Drive Extension or 1/2" Breaker Bar. This is a small unit. That grabs the lower control arm. So you can pull the lower control arm down to replace the lower ball joints. This is small and easy to use. I have a big bully type bar I use for this job. It takes up a lot of space to just store it. Smaller is better for me that does the same job.
Recommended Products