Your cart is empty.
Your cart is empty.Measure, mark and scribe trim lines on sheet metal in one easy operation. Set desired trim depth on scriber extension and tighten knob. The stop at the end of the scriber sleeve glides along edge of work as a 6 x 3/8" sheet metal screw point scribes a clean, hard line. Adjustable from 1/4" to 12-1/2" (6.4 to 318 mm) depths in 1/8" (3.2 mm) graduations. Rotate the scriber extension and knob end to end for depths larger than 6-1/2" (165 mm). The use of a Zip-In sheet metal screw makes point replacement practical and economical. Screw point is protected when tool is closed. Pocket size tool is constructed of rust resistant nickel plated steel. Knob assembly with hardened steel bolt insert will not strip out.
MIKE C.
2025-08-31 16:22:01
Very nice tool easier than a tape measure
TedSip
2025-08-14 13:59:27
Arrived promptly and well packaged. Made legible markings on sheet steel. Accurate and a lot easier to use than a tape measure or scale. Provides a replacement scribe refill as well. Useable for up to 12 inches from edge of sheet. The only challenge is to keep the scribe perpendicular to the guiding edge for maximum accuracy. Its sturdy, easy to adjust, ergonomic and well made. Recommended.
Dora
2025-07-28 15:44:13
Si me dió lo q necesitaba
Alex
2025-07-22 12:22:08
Measurements are dead on, durable and easy to use
mark isherwood
2025-06-29 15:40:10
had one lost it replacement
Kris
2025-06-10 18:40:39
Every Sheetmetal layout person should have one . I have 2 and my coworker has 3 .
dan
2025-04-30 16:03:49
This makes quick work to mark out your sheetmetal. The sheetmetal screw is a nice touch. The tip last a long time and it stays put. The marks are visible and accurate. It makes it better then using a marker. Especially when its raining or snowing.
Customer
2025-04-05 11:38:04
Works as it should makes laying out a bunch of the same piece very simple and fast, also love how its just a sheet metal screw for the scribe part quick easy and cheap to replace well thought out. instead of trying to put a point back on that small little area just grab a new screw and keep going.
Jaydon
2025-03-12 11:23:50
I had one for about ten years before the hook wore away. new one is amazingly aceturate. I'm getting more of these as gifts :)
Trevor N.
2025-02-07 09:39:34
Perfect
SAds
2025-02-02 12:08:14
I got two of these for my husband who works sheet metal. One for his work tool box and one for the home shop.The quality is quite good and he's very happy with the tool. He's kicking himself for not buying one sooner, for some reason we thought they would be expensive! Very very happy with these and the price is very attractive!!
William Budd
2024-12-29 18:34:05
itn does what it says it does and is a time saver at work. It marks metal aluminum and stainless steel.
dany ouellet
2024-11-19 20:44:29
Good quality
Recommended Products
