Shopping Cart

Your cart is empty.

Your cart is empty.

Mini Motion Sensor Light Switch 110-220V PIR Sensor Smart Detection Time Delay Adjustable Infrared Induction Detector for Strip LED Ceiling Lamp

Free shipping on orders over $29.99

$10.55

$ 5 .99 $5.99

In Stock

About this item

  • Infrared Sensor Switch working voltage :100-240V ; Load Power :≤40W ;Best sensing distance:3-5M ; Mounting Hole Diameter:25mm/0.98inch
  • There are 4 wires ,Red line is Live wire (L); the outermost blue line is Neutral wire (N);Yellow line and inside blue line connect to light bulb or energy-saving lamp .
  • PIR motion sensor switch has feature of small size and lightweight, easy to install and operate in room or cabinet, plug and play.
  • Function :Auto switch on/off in the dark when you enter into the induction range, and the time delay has 3 way of 15 seconds, 45 seconds, 5 minutes adjustable .In addition to the automatic control of LED lights, it can also be used to control exhaust fans, doorbells or other devices.
  • Widely Suitable for auto lighting corridors, stairs , bathrooms, basements, warehouses, garages,closet, advertisement light and other places.


Package include
1 piece of switch

Specification :
Working Voltage: 100-240V
Induction angle:110°
Best Sensing distance:2-5M
3-Way time delay: 15 seconds, 45 seconds, 5 minutes adjustable
Mode setting:dark(≤2Lux),dim(≤25Lux),all day(2000Lux)
Installation height:≥3.5M
Waterproof rating:IP22
Working temp: -20 ℃ -+40 ℃
Application lamps:LED lighting ,ceiling lamps,panel lights,floodlights ,etc.


daniel t nyce
2025-07-26 16:42:42
It's all good
Michael T.
2025-07-05 12:35:23
This motion detector switch never turned off. I tried every possible setting and lighting situation. It detected motion and turned on the connected light, but NEVER turned off. I even bought a second one (as the size is perfect for my use), thinking that I had simply bought a defective one, but it didn't work either.
ABDULBASET
2025-05-18 17:34:00
There is no any explain how many volts it works on
Varazdat S.
2025-05-03 17:07:50
I just installed it and turned on it works only for a single blink and just after it switching lights off and never turning on. And again if you turn off electricity and try again it will blink once and same.
DW
2025-04-10 16:57:17
This device works very well. Very simple and straight forward. daylight sensitivity and timer settings work as expected. My only reason for downgrading to four stars is that in typical fashion, the poorly translated wiring diagram is wrong. just consider your outside wires as your AC feed, and your two inside wires as your load, and you should get the results you are looking for. Can't complain for the price I guess.
Peter
2025-03-08 16:59:08
According to the specs provided, this motion was able to turn on and off a 120 volt fixture. Did not work at all for me. I am also a state licensed electrical contractor.
Jax
2025-02-18 21:17:05
Great sensitivity and worked straight out of the box. Using on Halloween display through a 20 amp relay. Only issue I found was its body diameter is bigger than standard junction box holes. Easy remedy though.
dan
2025-02-06 17:50:54
Not UL listed and seems to switch the neutral (not the hot)