Your cart is empty.
Your cart is empty.
1) Net Weight : 50g
2) Decoder;Material : Plastic, Aluminum
3) pieces Error Free Wiring Kit
4) Please make sure to mount the resistor to metal
Please note:
The load resistor on the decoder wire will get really hot, please make sure to mount the resistor to metal and don't touch it when the LED light is on
Chrislwells
2025-05-07 11:26:08
I bought these to work with another set I had bought from AutoZone. These run parallel with the lights, meaning one end goes to the positive and the other to the ground. Good wire - thick and good insulation. Much less expensive than the set from the parts store.
Meles
2024-12-09 14:42:14
Very nice staff
mrtiguan
2024-11-22 10:09:59
Was able to snap load resistors across stop light positive and negative wires using package hardware with the minimum difficulty. Prior technical experience was helpful as there are no instructions. My vehicle...2016 MB GL 450.Check Right and Left display error messages cleared.
Recommended Products