Your cart is empty.
Your cart is empty.The Optronics ALEDRST2BP is a LED load equalizer for making the turn signal flash at the proper rate when upgrading from incandescent to LED. 11" lead Length. 50W, 6 ohm resistor in-line. Mount to metal, resistors get very warm. Three Year
Dan Thompson
2025-08-28 17:45:37
Some may know, some may not. Older trucks do not like LEDs. These fixed my old Fords weird shifting issues because of an in harness ground. These provided the proper resistance and fixed my issue immediately.
Customer
2025-06-24 18:25:02
Used on obs ford with led taillights fixed cruise issue and hyper flashed also used on newer pickups to fix hyperflash would absolutely by again
Customer
2025-06-07 18:02:28
Takes 2 seconds each side to put in and stoped my fast flash, well dunk a shaaa to you!
Kevin Bazar
2025-04-25 17:21:23
I installed a flatbed with two LED tail lights that were causing the rapid flashing problem these are supposed to fix. they did not work. The lights still function as they did before, as if there were a burned out incandescent bulb. Not sure of the problem since there's another reviewer here who did the same and had them work.UPDATE: I put two resistors inline and that works. So I guess on some trucks/cars with heavier loads, one resistor is not enough.
Norwegian carpenter
2025-02-25 10:57:31
This fixed the hyper blink on my e350 on the left side after installing LED lights. The right side still hyper flashes. I swapped the kits and still a problem. Likely not the fault of this part. No idea how to solve.
Pyrozach
2025-02-18 18:20:01
Installed a flatbed on my truck with LED lights which made the blinkers flash fast, Removed 2 of the lights and plugged these in and were good to go!.
Recommended Products
$60.75
$ 27 .99 $27.99