Your cart is empty.
Your cart is empty.Product Description
Application
Mr. S
2025-08-08 14:46:38
The media could not be loaded.
Emily Monell
2025-07-28 18:49:07
I’ve ordered these guys 3 times and 1-2 connectors are useless. I have to order for a 4th time to finish off my cabinets. When they work, they’re easy and great, but you have to cycle through them to find one that works.
WrEcKs
2025-07-21 16:51:28
I bought these because I was purchasing a Pautix COB USB light strip for bias lights. This was my first experience with any type of light strip so I kinda just bought what Amazon suggested. I’m happy I did. These 90° corners aren’t rigid but aren’t floppy. I guess you could say they’re firm. It really allows for a clean looking installation.
S Blumenschein
2025-07-12 10:05:56
I have used these too many times with failing results to not write a review.I wish they worked. They just don't.They have this unfortunate feature where the swap the voltage and the control wires. This makes the next connection nearly impossible. These work for the first two connection with COB light and then you end up wasting foot after foot of perfectly good strip lighting trying to get them to work.Don't waste your money. They are just trash.
Raymundo Barrera
2025-05-17 16:03:48
The kit works as intended. Nice that they use a clamp design that isn't permanent, so that if you need to reconnect it, you can just open it up (by pulling the side tabs apart to release the lock) and reconnect as needed.This was one of the few items I found that would convert from 4-pin to 10mm CCT, which was helpful for using 4-pin extenders.
TLC
2025-03-17 17:43:23
Works on more than just Patix products. A bit fragile so connect with care.
Helpful Reviewer
2025-01-19 15:34:44
The L connectors and T connectors I tried made very poor connections and would cause the LED strip to not light, flicker, or just not propitiate the correct color or brightness down the line. I would pre-wire and test the strand and invariably the movement of the install would disrupt the contact in the L connectors.I had much better luck with the "Connection Kit" version that had wire connectors what were much more tolerant of being moved. The install does not look as clean if the strips are in direct view.There is a trick to lining up the connector's wire taps with the exposed pad on the LED strips. You do NOT want to insert the LED strip as far as possible into the connector as the tap will likely miss or make a poor connection with the LED strip pads.
troland
2025-01-08 11:19:06
Bought some to help me wire lighting in a bookcase, worked great for CCT strips that have (3) leads.
Recommended Products