Your cart is empty.
Your cart is empty.Product Description
Customer
2025-07-20 13:02:04
First of all, they came beautifully packaged. Everything was in perfect condition.Now, the fit and finish of these stands is outstanding. The black tempered glass is absolutely beautiful. Assembly is very easy and took 5 minutes. Once together, you have a solid stand that is simply beautiful to look at. It will add to the overall appearance of your bookshelf speaker. It will then have a very classy, elegant look.The pictures here don't do them justice. You have to see them in person. I'm using them for my front speakers, Klipsch RP-160M. They're pretty big and weigh around 20lbs. each and these stands hold them with no problem. And they look great on them!This is so much better than those cheap wooden stands (MDF) made of particle board, where the holes don't always line up and you end up splitting the wood when driving the screws. With this stand, all pieces are precision and everything fits/lines up perfectly.All in all, if you want to add beauty to your media room as well as having a nice solid stand for your bookshelf speaker, this is the one to get. You will not regret it. Worth every penny. Actually, IMO, it's worth a lot more than the selling price.Thank you Perlesmith for an outstanding product!
MSen
2025-06-13 18:23:03
Stands arrived in perfect condition. Assembly was fairly straightforward, and when done, the stands are sturdy and attractive. My only complaint is the set of stickers, carefully placed on the tops of the glass plates, which are difficult to remove and, once removed, leave a sticky residue which is also difficult to remove. Not enough to deduct a star but annoying.
A. Vali
2025-05-30 16:38:58
I really like the look of these stands. The tempered glass is nice & thick, and should be much easier to clean than MDF stands. I really like the larger floor base and speaker base. It should keep even the bigger bookshelf speakers very steady. My speakers are 7 1/8" wide x 11" deep and the placement looks really nice. Assembly was fairly straight forward. All the bits and parts were included, and everything fit together as expected. I love the larger floor spikes. Shaped well enough to keep it steady on the carpet without piercing too deep into it. I do have some complaints, none of which is worthy of a ratings ding.If I ever have to move the stands and/or replace the cables, I think I'll probably have to take it apart to get the speaker cable to thread through the bottom hole and come out the top hole. I have fairly thick, molded banana plug cables. On assembly, I ran the cable through the detached tubes before connecting them and attaching the ends to the plates. The center support rod came in two pieces, and there is a nut in the middle where the two pieces connect. I am certain the plugs will snag on that nut if I were to pull or push the cable through the assembled tube. I'd really rather not have to tug & pull to run a wire through. This is probably not an going to be an issue with thinner non-molded cables. It would have been better to have designed some form of cable management outside of the tubes. Also, the edges of the holes for the cable management are not smoothed out, so be careful about pulling cable through and rubbing on the edges. They're not super sharp, but they will scrape your cable if you pull hard and tight.Finally, here is no notch or guide (at least none that I found) that will allow you to make sure the top plate and bottom plate are correctly aligned. It may be an OCD thing to want to sides of the top & bottom plates be perfectly aligned, but most people will probably be ok with "close enough."Overall, I am very happy with these. They do the job and they look great!
Opel Dj
2025-05-16 20:35:38
Great Stand but I wish the hole for this wire management would fit an XLR cable and not just the speaker cable and power. Very nice and sturdy. Also, I wish it was 29†tall and not 28â€. The base is big and sturdy. Overall, it will do the job my mixing music and having more space on my table. I used the sticky tabs from my Yamaha and did not need there because it did not even move when I hit some high bass!!
ken
2025-04-23 09:25:10
I just needed a pair of affordable speaker stands but didn't expect the quality to be this good. What a pleasant surprise!
Phili
2025-03-30 09:00:08
Not adjustable. You have to figure out how to stick your speakers on top of the stand/base. You can use vecro straps
Malcolm D McPhee
2025-03-19 18:02:58
Easy assembly, wiring hidden internally to glass base. Looks great compliments speakers.
Gustavo Ara Cambrano
2025-01-06 18:22:04
The media could not be loaded.
digitalfishpc
2025-01-01 10:44:20
The speaker stands are very sturdy and capable of holding most bookshelf speakers but I am puzzled that only sticky pads were given to cushion the speakers. There's nothing to secure the speakers to the stands. Fortunately, most of the time the stands will be left alone but I expected more for making sure that my speakers are safe.
Recommended Products