Customer
2025-08-31 16:20:52
most halpful and no back problems in the moring...
laurie olson
2025-08-04 13:22:08
Purchased for my “man†(auto mechanic). Considering he’s been wrenching 40+ years, he needed this 3-in-1 body support system (neck/shoulders/back/knees). Less stress on his body to gitRdone. It’s sturdy, padded, easy to assemble, easy to use, not big and bulky, a great product choice for him. Very affordable, too. Wished I would have bought it for him sooner!
Robert James
2025-07-29 09:25:25
I whis I had this many years ago. Now, at 65 years old, crawling under a dash to change a blower motor, or a blend door actuator isn't as easy as it was 10 or even 20 years ago. The pinch Weld and door seam plays hell on the old back and sides. This under dash creeper makes it a lot, and I mean alot easier on my back and sides. I will go out on a limb and say you will not be disappointed if you buy one.
Darcy Cook
2025-06-05 18:48:08
Definitely helps in most situations on lower to the ground vehicles when working under the dash. The board could be a little narrower to allow leg positioning on both sides as it usually end up against the door rather than center of door opening. I glued a rubber strip to the bottom side to help keep from scratching plastic entry guards. Easier to carry than roll in under dash configuration.
David Anderson
2025-06-03 18:10:46
If you're working under a dash just do yourself a favor and buy this. I used it to swap out a brake booster. It's fully adjustable, very sturdy, (I'm 6'2" 260 lbs) and converts into a regular rolling creeper. It also has a removable part that functions as a knee pad.
MechEngrHog
2025-05-10 17:15:18
I have been looking at this for little bit wondering if it was worth the money (a little pricey). I had a blower I had to change out in a Lesabre and though it time was to bite the bullet. Two Words. Get It! It is still a pain to work under the dash but this saves your back that you have to contort over the door threshold. Worth every penny! Also, I had a problem with a bent screw when my new unit came in and the folks at alltradetools and Powerbuilt are customer focused and quickly resolved my bent screw with a new one. BUY IT! GREAT JOB Powerbuilt!Update just did a a/c blower on a 2002 Cadillac Deville (the first design blower that the internet says is the worst change), This thing is awesome! BUY IT if you are thinking about it!
Larry D
2025-04-21 18:14:10
I work under vehicle dashes all the time and this has been a great find. After having a surgical procedure my movement was limited for a time and this allowed me to continue working. On some smaller or lower vehicles it doesn't help much but for most of them this is a life saver!
Raul Espino
2025-01-04 21:35:18
This is a great tool for working under the dash of the vehicle. Very well-padded, multiple uses, and very efficient just an awesome piece of equipment!