Your cart is empty.
Your cart is empty.SECO-LARM E-931ACC-HR1Q ENFORCER Hood for Photoelectric Beam Sensor Reflectors, Use with either circular or square reflectors, Protects reflector from dirt and reduces interference with IR beam
SECO-LARM E-931ACC-HR1Q ENFORCER Hood for Photoelectric Beam Sensor Reflectors, Use with either circular or square reflectors, Protects reflector from dirt and reduces interference with IR beam
Key Features
- Use with either circular or square reflectors
- Protects reflector from dirt and reduces interference with IR beam
E. H. Kocijancic
2025-07-16 16:03:24
As expected
kslamplighter
2025-05-11 13:00:25
ok
scott
2025-05-07 11:23:05
This hood works well with the reflector shipped with the enforcer. However you need to trim the reflector, I did it with my bench grinder. Lightly trim all sides till it fit perfect in the slot. Took under a minute. There are knock outs on the inside of the hood for screws to mount first then fasten then reflector. Once installed the hood looks and functions great. Perhaps the oval reflector would not need to adjust/trim but the square one fits too snug without and doesnt sit flush with the set screws.
August
2024-12-06 17:33:38
The reflector supplied with the Seco-Larm is slightly too big to fit in the hood. There is no way to mount the hood. It is useless.
Recommended Products
$189.95
$ 93 .99 $93.99