Your cart is empty.
Your cart is empty. Features
Spread from 2 inches to 7-3/4 inches
Block is 8-1/4 inches wide
Forcing screw is 3/4 inch-16 x 11-5/8 inches long
Accommodates any cap screws up to 1/2" diameter
Function
Used to easily remove a wide range of gears, pulleys, or other parts that have tapped holes.
Michael D.
2025-08-12 12:55:25
This is an 8" bearing puller. It is a decent puller for the money.
kerri
2025-06-02 11:52:43
Very heavy duty puller. This is very well made. This along with some grade 8 hardware and you can pull almost anything that is stuck or frozen on. Excellent product
Countryboy
2025-04-21 17:06:50
I opened the package when I was about to start working on a project, that needed the flywheel pulled. After looking at the threads on the center shaft on this puller I placed the new puller back into the box and asked for return. The threads were very loose and I was afraid if I used the puller for this project it would pull the threads even on this first time use. The bar was heavy duty and the center bolt was heavy, however the machining of the threads caused my concern.The seller was quick to refund my purchase, which I was grateful. I did express my concern about the poor quality and my disappointment but have not heard anymore other than my refund. I do believe if they were to address the threading issue, it would be a good tool to purchase.
Samuel Cedeno
2025-02-22 14:01:16
The media could not be loaded.
Mark B
2025-02-03 12:12:45
Puller came quickly. Unboxed and inspected. Thread's look good, jam screw threads in easily. Used to pull a gear off a shaft. Seems like a quality puller. Make sure you lube threads and clean them when done, every time. Also, pull straight, don't overload.
HEROicDad
2025-01-24 20:37:56
Have used this multiple time on heavy duty applications. I lube the threads before each use and have not had any issues so far.
Matthew F.
2025-01-09 11:16:25
I wasn’t expecting much from a puller purchased from Amazon but this one is rather robust and puts out quite a bit force with each turn of the screw. The fit finish is equal to or better than some of my tool truck brand pullers.
Customer
2024-12-14 15:04:31
Got this puller to change bad bearing on my jeep. Stripped the threads before I got the job done.
Recommended Products
