Your cart is empty.
Your cart is empty.Product Description
CAT40 Face Shell Mill Tool Holder
- PROJECTION LENGTH: 1-3/8"
- TIR (INCH): 0.0002
- Made from alloy steel harden to 54-60 HRc
- All critical surface are precision ground
- Each holder comes with a lab certificate on its taper accuracy and runout measurement
Unique design feature in the flange to minimize the off-balance nature of CAT 40 taper specification. On the side of flange where a half spherical hole is located, a "wall" is built around this hole to compensate the weight of the metal chips lost from forming this spherical hole. This design allows the left side and right side of the holder to achieve 50-50 perfect weight distribution in its upright position, like the position inside a machine spindle. Symmetrical design in evenly weight distribution will minimize centrifugal force in high speed spinning and thus maximize the holder's ability to hold the cutting tool concentric to spindle rotation.
- T.I.R. 0.0002" measured from CAT40 taper to face and arbor
- H6 arbor tolerance to improve cutter chattering and overall cutting tool life
- Taper ground to AT3 or better accuracy standard for maximum contact with spindle. All of SHARS CAT/BT/HSK tool holder use Stotz Air/Electronic Gaging for production and finish inspection. Stotz has been chosen by major aircraft companies as the best and most consistent gaging for tool holder shanks
Luis C.
2025-05-02 14:00:28
Excelentes herramientas par Fadal Vmc4020
Mike
2025-01-20 21:16:19
Good for the money, would buy again
Recommended Products
$102.82
$ 40 .99 $40.99