Your cart is empty.
Your cart is empty.1
Gordon T. Womack
2025-08-27 15:00:40
These adapters worked great on multiple electric fan conversion projects. Just pair with an appropriately threaded themal switch
Richard J. Borcherding
2025-06-15 15:43:54
This fits inside the top radiator hose for a electric fan controlled thermostat. Remove a part of the hose and insert the coupler.
kram1961
2025-06-11 14:56:48
Can't really complain since it isn't designed for salt water. I wish I could find one in stainless or brass. If you use it in salt, be prepared to change it out every couple of years.
Kurt
2025-04-11 14:51:11
Nicely made, beautiful finish. Very helpful for older vehicles to install an electric cooling fan.
Fixer
2025-04-04 12:04:26
If you want to install a water temperature gauge because the in dash gauge stops working, you can't just wire it to the temperature sender in the engine block. That sends information to your car's computer to adjust fuel and air flow at warm up. You need to use the sender that comes with the new gauge and you need a place to screw it into. You can use the engine drain plug, probably with an adaptor or you can use this. You have to cut the hose from the radiator to the thermostat, then this clamps right in. Easy solution to a confusing problem. If you're worried, get a new hose as well to have the old one as a back-up if you have problems. I doubt if you do, though.
Ben
2025-02-12 10:48:36
Installed with blue gasket maker on hose. No leaks and temp gauge is very accurate. I like they had it in blue since my whole engine is anodized blue
Customer
2024-12-17 11:04:43
I ordered a 32mm version of this for my Honda but when i went to do the install it felt a little small. I measured with Mitutoyo calipers and it is 30mm not 32 despite being clearly marked as 32mm.
HqsTech
2024-12-09 18:46:56
Just like described
Recommended Products
$28.73
$ 13 .99 $13.99