Your cart is empty.
Your cart is empty.Product Description
TICK TINNED COPPER CONTACTS
- Easily tap into thicker insulation
- Work with solid and stranded wires
CONNECTORS CAN BE INTERMIXED
- Allows to connect different gauge wires
- All T Tap terminals use 0,25" male spades
MALE SPADES FIT IN TIGHTLY
- Mechanical stretch and Vibration resistant
- Can be easily disconnected if needed
Pops
2025-09-04 10:13:41
Work great and worth the money
BENNY NASH
2025-08-19 13:23:58
Just tap into one wire and the kit comes with spade connectors to slide in the slot to connect the second wire. So easy to use. the important part is to use the right size for the wire you are tapping. Too large and it will not have a good connection. too small and you might actually cut the wire in half or really weaken it. use a test light or ohm meter to check the connection before closing it up.
Court
2025-08-10 13:11:13
These are great for connecting wires. They are simpe to use and when properly attached give you a solid connection. My only gripe is because when using smaller wires such as 22 gauge, when you close the alligator clamp around the wire, the metal inside the clamp is supposed to cut through the wire insulation so that its a metal on metal connection. However, this doesnt happen for a lot of the wires and you have to first manually cut away some of the insulation so that there is a solid connection. Other than that, excellent product.
Shawn Ingrassia
2025-08-08 16:14:04
work great for what I was work on very easy to use.
John Lilley
2025-08-07 21:35:46
One thing I've noticed in these kinds of connectors is that the crimp of the spade is a weak point. These have a flared tube so that the insulation is grabbed differently than the wire, leading to a more secure crimp, especially for smaller-gauge wires.
Big Daddy
2025-06-30 17:29:34
My utility trailer and my garage door opener with battery backup have Spade connections. I use this product to splice into the wire and add a quick disconnect for a trickle charger to maintain the batteries monthly. Great product highly recommend to have in your toolbox.
Sleewok
2025-06-11 13:42:36
I decided to try these to tap into my backup camera for my vehicle and wire it to the new stereo I installed. Here is my experience: There were no instructions included. It is pretty self explanatory though. The wire was pretty small so I used the red taps (the smallest ones) I snapped them on and wired everything up. NOTHING happened. No signal, nothing. I started to question if I had the correct wires hooked up. I double checked that I installed with a quick google search. Sure enough I did everything fine. After an hour of messing around and reading I gave up. Later I took off the tap and looked at the wire. Sure enough the insulation had not been penetrated on the wire! It was compressed, but no wire was exposed. I used my fingernail (I recommend a sharp knife) and scraped away the insulation that had been squished by the tap. I reconnected the taps and amazingly everything worked!My thoughts? Definitely easier than soldering. I did not want to bring a hot solder iron into my car. I would melt the dash :D. It was not as easy as it should have been. Perhaps the gauge of the wire was a little too small? There seems to be a pretty fine line between cutting through the insulation and possibly severing some wire strands.I could just as easily expose some of the wire, twist it together, and use electrical tape. Based on this experience, the ONLY reason I would see myself using these again is the convenience of being able to plug/unplug them. I'll try them on a thicker wire, but I have already lost trust that they will make a true connection the first time I hook them up.
Shane
2025-05-17 14:47:19
Don’t have to crimp things often but having this kit around makes it way easy when I need to. I used this to tie in an extra brake light on my car and this made it a breeze.
SIL
2025-05-09 12:32:37
Très bon coffret, solution de raccordement très efficace.
Gia
2025-03-02 16:32:12
Worked like a charge to tap into the tail lights wiring for a rear license plate light install. Not sure about the waterproofing if it’s in an outdoor exposed location.
Martina Ullmann
2025-02-18 20:28:09
Gekauft um eine Rückfahrkamera im PKW anzuschließen.Diese Stromdiebe sind durch die Steckverbindung viel besser als die früheren Versionen wo die Adern fest miteinander verbunden wurden.Dafür gibt eine klare Kaufempfehlung.
còaudio
2025-02-11 21:05:26
OK
Customer
2025-02-02 16:08:00
These items are very good and very handy, when connecting two different wires together.Very easy to use as there is no cutting involved.
Recommended Products