Your cart is empty.
Your cart is empty.Product Description
There are protective films on both sides of shatter resistant plastic sheets
Made of polycarbonate material, transparent and lightweight
Cut the clear sheet into various shapes according to your preference
Chris K.
2025-09-04 15:10:48
This was the perfect material to use as a top cover for my 2 gallon nano tank. It looked extremely transparent, almost like nothing was there after I was done cutting it out with scissors. If you wipe it with anything however, it'll scratch very easily because it is plastic after all.
Kevin
2025-09-01 16:05:00
These are exactly as described and was exactly what I needed. I was a little hesitant to try them, seeing as how one reviewer said they weren't clear. I had purchased polycarbonate film from another retailer (not Amazon) and those were described as clear, but when it arrived it was actually a velvet clear finish (which is a little cloudy) and it had no protective film on it, so I could see some fine scratches from storage and shipping. That's not what I wanted. I needed absolute crystal clear. So I decided to try these.Bam!! exactly what I was looking for. Clear as glass after you pull off the protective film on each side and no scratches, thanks to the protective film. Perfect!Be aware....They are .020 (20 Thousandths) of an inch thick. Don't expect anything different. If you're not aware of how thick that is...get a set of calipers and look before you buy.
KP
2025-08-20 20:05:26
I added this to the bottom of my Table Saw Miter Gage to eliminate the metal to metal contact. It was easy to trace the outline with a fine point Sharpie and cut with a utility razor and scissors. It attached firmly with very thin woodworking double-sticky tape. This stuff measured .5 mm thick and does have a removeable protective cover. Very solidly feeling polycarbonate.
Jonathan
2025-06-10 12:33:30
Looked good coming out of the packaging and is crystal clear. It cut well enough on my sheet cutter, but it just caused me to brake my cheap new hole punch. So I ordered a new hole punch and round two starts tomorrow.
Roberta Maytum
2025-05-17 11:13:08
I'll be using these as a glass protector on my sand blaster cabinet.
Bettikins
2025-04-27 18:19:33
These plastic sheets were exactly what I needed.
TrueVision
2025-03-28 14:43:18
I wanted to use these on my glass top tables to avoid scratches during parties. They are good quality, but they aren’t crystal clear. They have a slight film over them.
rickinohio
2025-01-07 18:49:11
I couldn't find a decent aftermarket lens for my Miller Classic welding helmet and the OEM is just to ridiculously expensive. While the OEM lens is thicker at 1mm, the inner lens is mostly just a dirt shield for the auto-darkening lens and is not a safety feature (that's my opinion). And because the material is so thin, it easily cuts on my paper cutter. You could just as easy use a pair of scissors too. And for $12, I'll probably never have to buy another inner lens.Sheets come with protective plastic on BOTH sides. One side is green and it's obvious, but the other side is clear, so remember to peel that side off too!
Recommended Products