Your cart is empty.
Your cart is empty.Product Description
Carbide Square End Mill for Steels, HRC 55 Deg, 4 Flute, AlTiN Coating End Mill Bits for Milling Alloy Steels, Hardened Steel, Metal & More
Jim bo
2025-07-29 15:20:23
Will buy. A Gain
Zack L.
2025-06-16 17:20:02
First off, I'm not a mill guy. I can't speak on the true quality or longevity since I have no real milling experience. However, when I used it in my palm router to mill out 2 1" holes 3/4" deep it did an awesome job. I also used it to shave a steel rod down to the diameter I needed and again it performed well and is still very sharp. I would absolutely buy one if these again if this one dulls out.
Blake
2025-05-30 16:26:50
Machined 303 stainless very well. I am pleased with the quality especially for how much they cost.
travels
2025-04-18 11:18:36
I used it to cut a keyway
Jason Owens
2025-04-12 11:18:15
I bought this to cut out a broken tap in a part I didn't want to scrap. It worked great for that, chewed through it like a hot knife through butter. However, it chipped on me part way through (but I powered through the tap anyway.).It was probably my fault though, being an amateur machinist. Maybe rpm was too slow??
Oldshoes
2025-03-25 16:30:43
The media could not be loaded.
Dual-500
2025-03-24 15:20:55
These are good cutters. They will plunge cut into mild steel without any chatter or problems and are sharp so they cut nice and smooth. I use them most times dry.
matthew
2025-02-11 15:58:59
since i had to buy a 5 pack i have been using these as my go-to for some random tasks thinking I could break one here or there, but im still on the first and impressed with the quality of them.
Recommended Products