Your cart is empty.
Your cart is empty.Premium-quality micrograin solid carbide bit is precision ground for an Extra-Fine finish With maximum sharpness and edge retention. Flush trim bits are used for laminate work or for template and pattern work. For template application, the bearing follows the template, while the cutting edges trim The work piece.Single flute trim Bit allows for a faster feed rate. Solid carbide gives Best rigidity and long life.
Melissa
2025-09-03 13:23:17
Great bit, good value for the price. Did exactly what I needed it to for trimming laminate sheets.
Jose soto
2025-08-18 13:23:32
Entrega rápida
DAVID J GRIMMER
2025-08-13 13:37:43
I use this bit to cut the tabs left by a CNC router. I use it in a small trim router and it does a great job cutting through the thin tabs holding my product to the board it was made from.
David
2025-08-12 18:17:00
Maybe it’s just me, but it broke almost immediately. There is no cutting edge on the top so when hit a small obstacle with the tip it was done.
Dave H
2025-07-27 12:08:33
Not much to say, but this worked great as advertised. Used a small amount of household oil on my fingertip and made sure it was lubricated good, then went at a normal pace. Do not hold against the edge without moving or it will burn. Clean up the oil with some solvent and hit the edge with a file to smooth it down a little.
Kim
2025-06-20 17:12:16
Would buy again.
Luis Ibarrondo
2025-05-15 11:48:48
I would recommend this tool if your cutting laminate
Timothy
2025-05-07 12:18:13
This laminate flush trim bit was sharp and worked well. However, it let scratches in the laminate sides where the bit rides.
Terry B.
2025-02-21 14:12:25
worked nicely, it did put a faint line in the side but lets face it I bought it knowing it didnt have a bearing so I wont hold that against it. It was a good price and I only needed to do a couple cuts.
Norm L
2025-01-31 16:21:15
Bought this to trim veneer on my speaker build for the speaker cutout. workfind for the woofer but the tweeter depth as not deep enough for this bit to work.
Recommended Products
$10.95
$ 5 .99 $5.99