Your cart is empty.
Your cart is empty.Paul
2025-06-03 14:14:24
The product works great I've tested it on a 12 volt light bulb was not able to try it on my fan motor which is at another location, but if it works on a 12v light bulb it will work on the 12v motor.Highly recommended and great value.
Tracy
2025-05-23 17:08:13
These are ok quality wise, in other words they will do the job, for how long I don’t know. These did not include instructions for installation
Snake Doctor
2025-05-11 13:12:32
No instruction for connecting the variable on/off controller switch were provided. Once connected correctly, It worked extremely well. I am glad that the package included three switches for more projects.
Floyd
2025-04-01 18:07:13
I use these for custom car heater fan control, they work great.
Peter Jay
2025-03-19 18:07:52
The wiring is not intuitive. You would naturally wire black to minus, red to incoming power and blue to motor power, but this is NOT correct. Follow the diagram.Meanwhile I wired these to some fan motors in parallel of less than 1A each. The off position is definitely off, but at the lowest setting, I read something over 7V. Frankly, these should have much greater range.As for longevity, I don't have enough experience with these yet. Others have reported overheating and burnout. Time will tell. Not sure though, if I can use them due to the lack of low-end voltage range.
JOY
2025-03-04 16:13:05
The media could not be loaded.
Daniel
2025-02-02 12:50:17
Great product but how do you keep knob on
Fletch
2024-12-26 16:49:54
I had one that got hot, so it was destroyed. Ordered 3 this time and hooked up a dc brushed motor and it over heated to the point the heat sink was 225F and melted the plastic behind. I was only using a 12v 10amp motorcycle battery.Ran for 4 minutes before it cut out and then overheated. See pictures.
Recommended Products
$15.99
$ 7 .99 $7.99