Your cart is empty.
Your cart is empty. Be used for gear rotation speed measurement
Combining the advantages of stable signal, wide range of operating temperature, small size, simple assembly, etc
It covers a wide range of measurement, and it is able to
measure the zero rotation speed
Operating temperature:-30 ~85℃
Output signal: sine wave
Signal duty factor: 47±5%
Inductance distance: less than 1mm
Connecting way: two wires connecting
Protection rank: IP67
Robert E. Stanton
2025-08-31 18:00:15
Installed on our Jinma 354 farm tractor and it works great in place of OEM. Much cheaper and easier to get also.
timsshop
2025-08-11 12:57:27
I am adding a new tachometer to an older vehicle. There is NO information on how to use this recommended item with the tachometer.
John Reily
2025-08-09 11:07:42
Works great! It didn't come with instructions or a mate for the connector that is attached. One wire to ground or negative on the battery. The other wire is signal. There appears to be a magnet built into the unit and you need to mount a magnet (supplied by you) on the shaft. Also had to fabricate a mounting bracket. If it included these items I would have given it 5 stars
Tracy
2025-08-05 18:14:51
Support for this product was awesome. They sent the install instructions (see attached). However, I could never get it to work with the ELING tachometer. I tried sensing vanes on the alternator and adding a magnet to the water pump. I do not have access to a "transmitting gear" on my engine (MerCruiser 4.3L V6). I am going to design a spark plug wire transmitter to see if that works. Product will be returned.
Tom
2025-06-15 14:28:36
The media could not be loaded.
jimfrer
2025-05-28 14:12:12
There were no directions with it what so ever. If I normally install them that would ba a problem but I do not install them everyday, possibly just like the majority of people who buy them.
Tommy T.
2025-05-18 18:56:17
The media could not be loaded.
Brad Bradshaw
2025-04-25 14:46:47
Works well with the Cummings tack/hour meter
Michel Neault
2025-04-05 11:28:42
Parfait
Client d'
2025-03-29 18:20:22
La pièce sèche dans une boite, ca fait dur comme explication.
Q
2025-03-15 16:11:32
should be more detail on wiring to tach.I am going to try this on a 5.9 cummings for my crank sensor using the balancer for the signal pickup.
Peter L.
2025-02-08 15:18:56
This worked well as a tach sensor, mounted on torque converter cover to read flywheel teeth. Some careful measuring must be done, and you will have to find a nut with the same metric threads to use as a bung to weld onto the cover. I added an inspection hole to the front of the cover also so I could adjust the clearance of the sensor to the flywheel.
Recommended Products
