Your cart is empty.
Your cart is empty.Product Description
captain Ed
2025-08-30 21:36:21
It was a exact good quality 7 mm button for my handicap elevator circuit control stations to operate relays that controlled hydraulic systems solenoids, motor controls etc , system has worked flawsly for 25 years , with exact same buttons , I put brass nuts prevent rust exterior exposure, excellent value
Kimo B.
2025-08-05 14:27:36
These "micro" switches work great and serve their purpose. These are "momentary (non-latching)" normally closed switches that you push to open the circuit.
Luke Webb
2025-07-21 16:24:49
But this in a bass and worked exactly as it was supposed to. They were a little smaller than I expected but work great.
Cliff
2025-06-06 15:19:14
As advertised. Perfect size for the hole already in place of my application. Thank you.
Jeff
2025-03-31 14:27:46
Having purchased switches claiming to be normally closed elsewhere and receiving normally open I was reluctant to buy these. However I must say I received proper working switch and may now finally finish projects. Is a shame I had to purchase 10, but as others have said they may prove usefully an some other project. Thank you!
Luke
2025-03-25 14:49:44
The switch failed when soldering to the legs on two soldering attempts on two different switches.The switch travel was reduced after soldering, so the plastic must have melted inside the switch.I'm experienced with electronics fabrication and didn't overheat the part or waste time soldering. I'm also skilled enough that I find cold solder joints unacceptable. I had the same failure on several switches in a row. It appears that the plastic in these switches is not electronics-grade and connot survive a typical hand-soldering process.The legs are designed to have the wire soldered on, but please only consider these switches if your application does not require soldering -- or if cold solder joints are desirable in your application.
R. Stone
2025-01-16 16:16:16
Switches are tiny, as others have mentioned, but seem to work ok. The description is wrong though. You get five red-capped switches, and five black-capped switches. The red ones are normally closed, and the black ones are normally open. Might be best to test them with a continuity tester before installing them.
Customer
2025-01-10 11:01:01
Perfect match for game box. Simple to replace. Buying 10 is overkill but price was fine because of match, and the push button switches are useful for other homebrew projects.
Recommended Products