Your cart is empty.
Your cart is empty.Product Description
Solid State Relay 40DA
Load Voltage: 24~480VAC
Load Current: 40A
Input Voltage: DC 3~32V
K Type Thermocouple
Temperature rang :0-400℃
Sensor Dia: 0.18inch (4.5mm)
Cable Length: 6.6ft(2m)
External Shielding: Insulated Shielding
Internal Insulation: Fiberglass
Black Heat Sink
Screw Thread: 3mm
Roof: 50mm x 60mm.
Foot: 80mm x 50mm.
Height: 50mm
Package
1x CGELE PID(Proportional Integral Derivative) Temperature Controller
1x 40DA SSR,1x Mounting Bracket
1 x K type Thermocouple,1 x Black Aluminum Heat Sink
2x Mini Bag of Thermal Grease
2x Screw,1x Instruction Manual
MS
2025-08-28 10:11:11
Works great.
rob
2025-08-09 12:42:41
It looks OK I haven't hooked it up yet
Paul Dunn
2025-08-08 13:54:11
Temp was off about 14 degrees out of the box. The instructions are cryptic to say the least.Wiring it up was straightforward, then I saw temp was off, so a quick look at the instructions says P13 is temp offset. OK, dig through instructions to find how to get to setup. In the flowchart it shows to hold SU (SV? can't read it) for 25 seconds. OK, got it. it turns to P00, you can then hit up/dn keys to scroll through settings, but ... P13 never comes up.P00 is data lock, the manual shows valid values are like 0,1,18, etc. but doesn't say which does what.If you buy one of these, 0 locks out most settings, 1 opens a couple, 18 opens more.So to set temp offset, hold the button for 25 seconds, when it changes to P00 set the value to 18, now you can get to P13 to put in a temperature offset. (it is concerning that the offset is this large, most of my other controllers are name brand and I've never needed this big of an offset)Also of note: I'm running a heater on this, 1800 watts, in a room with an ambient temp of 55F. The heatsink hit 110F !!! There seems to be quite a bit of internal resistance on these SSRs when there should be essentially none. Needing to de-rate an SSR based on load is a bit concerning, but, for a PID, tc, ssr and heatsink that costs about half of a single Opto22 SSR, I guess I can't complain. it seems to be doing the job.Only time will tell if the thing will last
Honest Abe
2025-05-19 16:51:40
The media could not be loaded.
Kevin krueger
2025-03-02 13:36:45
Good
Roberto Santana
2025-02-27 12:18:48
Hot treatment oven
Disatisfied customer
2025-02-25 11:11:28
I bought this for a temp control project, it would not recognize the k type temp controller it came with, or the second one I bought. Menus confusing to navigate, instructions are not clear. I ended up getting an inkbird that was much easier to use.I was not able to return this since it was past the return date.
Bobby Ackerman
2024-12-14 17:09:02
We bought this item to replaced the original one that burned out in our unit. The packaging was good and we were eager to install it, which was super simple. So far we have not have any issues with it, and we are hopeful that this one will last for a long time. I recommend this product.
Ayush
2024-11-30 09:59:23
Works well for me, just wiring circuit diagram given with it was little wrong.
Recommended Products