Your cart is empty.
Your cart is empty.Product Description
WIDELY APPLICATION
mitisha
2025-07-19 10:41:42
Works great better than I expected do not buy the cheap solar controllers spending the money it's worth it. Installation was easy the build quality is strong zero noise level and the heat dissipation is not a factory has not gotten hot.
Thunk About It
2025-06-15 15:21:10
Unit was in use for about 1.5 years before it failed. Setup and operation with LFP batteries was not very easy since the Lithium settings in this unit were catering to the NMC type of lithium voltage ranges. I had to use the custom battery settings and I could only get it setup close to what I needed.After the PowMR MPPT Solar Charge Controller 60A failed I the Contacted seller and learned that they do not support their PowMr MPPT Solar Charge Controller 60A in any way regarding repairs. They have no local repair center and they will not provide any electronics schematic so that it could be repaired. They claim that they can not share their schematic for this 50 year old technology because it is a secret. What a sad joke of customer service.So if you purchase one of these POWMR MPPT Solar Charge Controller 60A Please understand that it must be put in the garbage bin when you experience any failures with it.You may want to consider a better supported Solar Charge Controller for your projects.Good Luck!
MONO
2025-05-27 10:11:16
Works well, actually works great ! Replaced my failed Renogy 40Amp with this and it's held up great over the last year. Can't beat it for the price and has already outlasted the Renogy! Added another 2 panels and it's consistently putting 500 watts or better during peak hours.Recommend !
Salvador
2025-04-17 16:10:48
Lo tengo a prueba funciona muy bien pero el manual es una basura muy poca información y muy difÃcil de entender. En cuanto rendimiento está funcionando bien
BoozyPickles
2025-03-25 21:37:24
After multiple units either failed to keep charge or just over heated/smoked/fire, this worked. This unit is far more superior, stays cool and most of all keeps my batteries charged. I am looking forward to purchasing a second unit for another array I am setting up. Right now I am using the Eco-Worthy Solar track with just under 1200w of power. Due to the size wire and voltage limits of this unit, I was able to run this array in a series/parallel connection to keep the amps around 30 and the voltage around 90-100v in full light.
johnson
2025-02-26 15:40:20
Thank just what I need AAA+
Cuong Vu
2025-02-03 13:38:52
First, you won't get a response from their support email/form listed on their website. You're on your own. Next, the manual is very vague about configuring to work with LiFePO4 batteries. I did set it to the Li settings, but the parameters are too low (float charge starting at 12.8 Volts), causing it to not output current from the solar panels on the Li settings. I then used the user defined option and set float charge at 14.4 volts and then it output current. Unfortunately, it didn't stop charging at 14.4 volts and never stopped outputting current. My batteries have internal BMS to prevent overcharge. My system was at 32 volts when I realized what it wasn't following the float limit of 14.4 volts that I previously set. I immediately cut off the solar panels where I think it discharged its power into the system causing my circuit protected, off state inverter to blow due to the high voltage, creating smoke from it. I wouldn't buy this product even at the lowest price of $100. You get what you pay for. Returning it this week.
D K N
2024-11-15 10:03:05
Been about 6 months pulling around 900 watts Max in my 48v system and still going strong.
Recommended Products