Your cart is empty.
Your cart is empty.Product Description
Ideal for Electrical, Piping, Conduit Work, Sheetmetal Fabrication, Spotweld Removal, Maintenance Installations, HVAC, PHCC, Automotive Aftermarket.
INSTRUCTIONS FOR USE:
STEP 1: WEAR PROPER SAFETY GEAR: Safety glasses, gloves, and protective clothing are essential.
STEP 2: PREPARE THE SURFACE: If the spot welds are rusty or pitted, sand the area down prior to cutting to ensure a level cutting surface
STEP 3: LUBRICATION: Lubricate cutter drill guide bore and cutter body.
STEP 4: SELECT THE CORRECT SPOT WELD CUTTER SIZE: Use one that matches the diameter of the spot welds.
STEP 5: MARK THE SPOT WELDS: Use a center punch to make a divot to ensure the bit does not walk.
STEP 6: ALIGN THE CUTTER: IMPORTANT Position it perpendicular to the surface of the workpiece. It is important to stay as square as possible throughout the operation. Cutting at even a small angle will cause the teeth to break.
STEP 7: APPLY STEADY PRESSURE AND START SLOWLY: Start slowly and apply consistent downward pressure on the cutter.
STEP 8: CUT THROUGH THE TOP LAYER: Allow the cutter's teeth to remove material around the spot weld.
STEP 9: CLEAN UP: Remove any burrs or sharp edges from the workpiece.
Customer
2025-08-29 18:40:43
Run them slow, keep the cutting area lubed with a good cutting oil, works fantastic.
levi
2025-07-12 20:10:42
Worked perfectly I did use cutting fluid on all my cuts, but it did not have any trouble drilling out about 12 spot welds in about 3/16 steel very happy with it
Jim Crang
2025-07-06 21:30:16
This product is far superior to others I’ve used in the past.
oldhearted
2025-06-07 16:55:19
The cutting tool works great when drilling out a weld, but when removing the cutting head is hard at times. Just wondering if the washer or spacer on the tool is to be set one way or the other way, would be nice to know in some instructions as to washer curve is up or curve down.
kilrain
2025-06-02 17:07:09
Just tried it on 1/4" thick ibeam using the 7/16 bit. A little bit of tap oil and it cut through with minimal effort.It is a challenge to remove the bit from the extension though.
Greg
2025-04-14 16:16:27
Good value and they listen to their customers, they added replacement pins + individual bits.
Renee Penning
2025-02-21 16:27:13
My husband used them on sheet metal, broke 2 of the bits but company replaced them very promptly
LarryH
2025-01-29 17:47:25
This is a great item if you need to cut holes in metal and are tired of using drill bits. The holes are very clean if you take your time and use cutting oil. I used a Dewalt cordless drill and had great success. It comes in a nice compact case with directions on the case and it has a center punch and pilot pin. Not something I will use on a daily basis but for a small investment it's nice to know it's there when I need it and it takes up very little storage space. Very handy addition to my tool chest!
Recommended Products
$179.95
$ 81 .99 $81.99