Your cart is empty.
Your cart is empty.Product Description
Information
Taps can be divided into straight flute thread taps, spiral flute thread taps, spiral point thread taps and thread forming taps. They are also divided into hand taps and machine taps according to the usage. Hand taps are operated by tap wrenches. Machine taps are suggested to be used with tap collets with overload protection. Recommended feed rate: General steel: 6-15m/min; harder steel: 5-10m/min; stainless steel: 2-7m/min; cast iron: 8-10m/min.
Straight Flute Thread Taps
Straight flute design, downward chip removal, fast tapping with accuracy. Suitable for processing through holes or shallow blind holes.
Easy to Use
Used on drilling machines, tapping machines, CNC and milling machines. Use with tapping oil to get higher quality threads and more durable taps.
Coatings
Features just the base substrate without any additional coatings, suitable for wide ranges of applications.
High Speed Steel Taps
- High hardness and strength, good toughness
- Good wear resistance and heat resistance.
- Good process performance.
- Perfect for drilling and tapping aluminum, zinc, alloy etc..
jesse
2025-07-13 12:43:40
Needed these to clean out holes in old Toyota truck frame. Worked good and didn’t break during use which is the most important thing to me . Have no complaints with these .
Customer
2025-05-07 11:58:13
Thread holes were rusted out and ruined on my 05 Liberty when I went to install a bolt-on trailer hitch. Hard to remember exactly but I think hitch was supposed to bolt on with 10mm bolts but couldn't get any to fit properly, so I had to go up to 12mm. These uxcell 12mm taps did the rethreading just fine! Used lots of "cutting fluid" (WD40 worked fine). Used in conjunction with Hanson 1766069.
Chance
2025-04-01 14:56:22
Installing an off road bumper I had managed to damage the threads on a 12mm frame bolt/receiver on my Toyota. This tool took me less than 5 minutes to clear the damaged threads and restore them to successfully install the bolt. Make sure you match the thread pitch, go slowly and use cutting oil. I would buy them again!
that other dude!
2025-03-22 14:59:36
Great quality for the price. Worked well chasing messed up threads.
Sean E Willey
2025-03-05 17:54:53
I bought two thinking Id have a back-up if needed. Nope. First one out of the bag took care of business.A closer look and you wont find a flaw. I wonder if they have a set.
Ansuman Pal
2025-02-19 11:40:36
I am no expert but it just works. I will recommend it as long as the steel thickness is not more than 1/4 inches.
Van Nguyen
2025-02-06 10:35:34
I bought this for a gun barrel thread, but barrel thread are actually 1/2x20 (I think).
Shannon L.
2024-11-24 10:34:38
Worked perfectly to fix my tractor.
Raynald Nicol
2024-11-16 15:45:05
seems to be ok....this is to be used at home.....so they may last ......To be use every day you have to try it!!!
Recommended Products