Your cart is empty.
Your cart is empty. Description:
1.Pressing the ON button is a self-locking state. When the OFF button is pressed, the ON button will reset.
2.It is characteristic of accurate on-off loaded current, safe and reliable high intensity of machinery.
3.Widely in machine tools, textile machinery, etc. The switch is the best choice for machinery power.
4.This switch can control three phases motor directly, no need to use magnetic switch. Screw terminals ensure easily wiring.
Specification:
Product Name: Push Button Switch
Model: TBSN-330
Material: Metal
Type: ON/OFF
Voltage/ Current:380VAC 30A
Mounting Hole diameter: 4mm/ 0.16"
Total Size (Approx.): 105 x 63 x 54mm / 4.13" x 2.48" x 2.12" (L*W*H)
Package Content: 1 x Push Button Switch
james moore II
2025-06-21 10:58:15
Cheaply made but works well for my air compressor. I’m sure it will hold up.
Ed R.
2025-04-18 15:24:25
Poorly designed, metric knockouts will not work with standard fittings. Very tight area cannot use #12 wire.
Tom B
2025-03-15 14:00:22
Just the right switch I was looking for.
Joe
2025-03-02 14:42:17
I didn’t like that the inlet/outlet wire holes are not the size of standard wire clamps so there is nothing to secure the wires going into and out of the box. The small contact screws were tough to set. However, once it was installed it works fine.
David D.
2025-02-20 15:01:22
Works fine. Little snug for wire hook ups but patience pays off.
NelsonPaulNC
2025-02-19 18:03:19
Tried to use standard 1/2†electrical fittings on wire entrance and exit. Holes are too small.
scott
2025-02-16 18:25:32
switch failed after one week of installation. It will not switch to the on position and transfer power to the non powered side of switch in any switch position. I tried the replacement and it only worked for 2 weeks...same problem, it failed to transfer power in the on position. The holes to attached conduit adapters need to honed out they are to small. Terrible product, stay away.
Steve weston
2025-02-04 15:34:11
I wanted just a basic switch and this one exceeded what I thought I would get. Great switch and recommended.
Craig Fairley
2024-12-29 21:56:06
I used this switch for three wire 240 volt, 15 amp two horsepower table saw motor. It was easy to wire up and fasten to the table saw. Works perfectly, a great purchase.
Customer
2024-12-05 12:13:10
10cm Lx 6cm W instead of 12 x7 .Bought because of the advertised sizeQuality looks good,will find a use for it
Recommended Products
