Your cart is empty.
Your cart is empty.Van Mark introduces the Multi Gauge, designed to make your job easier by assisting with determining both the angle of the metal being bent and lining up your TrimCutter Cut-Off Point.
Hampton
2025-08-19 16:40:33
These are not worth the material they're made of. They barely hang onto the machine and fall off when you try to bend the metal. We had to add velcro strips to the machine and these pieces so they didn't continuously fall off. They're in the way when you try to cut the metal.
Gutter Guy
2025-08-08 18:47:45
This is a great addition to my brake. I recently had to bend nearly 700' of drip edge at a 55 and 60 degree angle. The Multi Gauge made this task a breeze.Draw back is the price. At $73 they probably won't sell a lot. $49 seems like a top price and they would most likely sell many more.
No ya biz
2025-07-22 18:28:14
Good for marking 1.5†from break for cutoff tool, but limited value otherwise. Can be replaced with a speed square and a pencil otherwise.
Customer
2025-05-29 12:18:57
works great
Anthony Torieri
2025-02-06 12:03:40
a bit expensive for what it is
Recommended Products
