Your cart is empty.
Your cart is empty.Product Description
Multi-scenario use to meet your needs
VCE low voltage mounting bracket can meet a variety of wiring needs such as HDMI, coax, Speaker, RJ45 and so on.
Brush wall plates, rubber wall plates or keystone wall plates can be used with them, as long as they are of a standard size.
Fits wall thicknesses between 0.157 and 0.787 inches.
mimzhan
2025-08-11 13:32:31
Delivery was fast! Product works really well. Easy to install.
Gene
2025-08-06 16:40:39
They work as advertised. It is a simple device; but the knock off versions get it wrong. These folks got it right.
George Russell
2025-07-25 12:30:31
I used these to install network and cable panels in homes that were already finished. Very simple to use especially if the distance between walls is very short.
Mr Person
2025-06-27 16:08:51
There is a little bump where the screws are, so if you mark the wall with the provided dots, and cut perfectly, it will have trouble fitting, but a little pressure and it went in fine. As you can see I got these for Ethernet jacks, and everything fit fine. I do wonder if the threads will hold up if I have to take the face plate off and on as it felt like I was cutting the threads as I screwed on the plate, but I don't think I'll have to remove it often.
Kurt Schroeder
2025-06-22 13:34:12
Fit like a glove
Shane B.
2025-05-29 13:44:23
If you think it’s even remotely tight, stop tightening. They snap as soon as they get snugged down.
Tracey C.
2025-05-06 12:21:45
Met my needs and expectations
SK
2025-04-20 17:06:13
Mounting ethernet ports in my office down to my living room so that I can move my modem/gateway to a better location for the rest of my home. These will serve that need as expected.
Tim from Canada
2025-02-15 20:26:34
These work great if you have to install cable, telephone, networking, even a plug in. It's just with a plug you have to brace the wire, not sure it's code. Works really good for audio visual hook ups, The price is very reasonable.
André
2025-01-26 14:10:38
Une prise Videotron et le résultat est excellent, aucune difficulté a l'installer. Je recommande ce produit qui élimine un petit problème de plaque.
Amy
2025-01-09 18:52:48
I've installed hundreds and hundreds of low voltage plates over the years. These are very very similar to certain orange, much more expensive ones. They are perfect for running speaker wires, data cables, anything low voltage, and they snug up well in the drywall... just don't overtighten them, because they will warp out of square. The expensive ones do it too! It's not a fault with THESE ones, it's just the nature of a flexible plastic frame. As long as it's not jiggling freely, it's tight enough. Your faceplate will snug everything up at the final finishing stage. These are a much more economical, equally effective low voltage plate and I can't see me going back to the orange ones any time soon.
Reviewed in Canada
2025-01-07 13:45:20
This is a pack of low voltage mounting brackets. If you’re not running electrical cable and instead are running Ethernet, HDMI, speaker, etc. cable then you don’t require a full electrical box. You only need a bracket like this one, just to provide something for the wallplates’ screws to attach to.No instructions are included, but there are instructions in the listing. Basically, once you make the hole, there are two “wings†at the top and bottom that push against the drywall once you tighten it with the screws.The only issue is that the wings are blocked from rotating fully and these blockers are approximately 1-3/4†deep. Therefore, you will need that much room behind the wall. Normally, this is not a problem, but you might have some blocking (wood between studs) or other obstructions that might get in the way.
Recommended Products