Your cart is empty.
Your cart is empty. LED Load Resistors 6 Ohm 100W for LED Turn Signal Light Fix or LED License Plate Lights Error Fix.
These 6 Ohm, 100 Watt LED load resistors will work on any vehicle and can be connected across the turn signal bulbs or License Plate Lights to simulate the load of a regular filament bulb (2 Amp load).
This will solve LED related turn signal lights or license plate light problems such as hyper flashing, no flashing or burnt out bulb indications.
One LED resistor is required for each turn signal bulb or each license plate light bulb.
Features & Specs:
- Brand new and high quality
- Can be used with vehicle turn signal light's LED conversion
- Solve hyper flash or no blinking of turn signal
- Each LED bulb installation requires one resistor connected in parellel
- Voltage: DC 12V
- Power: 100W
- Resistance: 6 ohm
30-Day money back guaranteed and 1 year replacement warranty.
Legal Disclaimer
CAUTION: Load Resistors get EXTREMLY HOT when working. DO NOT mount on plastic.
reefbum
2025-07-03 13:26:36
I used 1 of these to make a controller precharge circuit for my Ryobi ZTE 48volt zero turn mower. When I swapped out the 4yr old lead batteries for new lifepo4 batteries. The startup amp draw from the controller was tripping the BMS on the lifepo4 batteries. With the use of this resistor and 1 5pin relay and 1 10 second delay on relay I was able to make a precharge relay circuit that precharges the controller capacitors for 10sec before engaging the main power relay.
Singh Ratanvir
2024-12-06 16:47:35
Works great
Recommended Products
$45.00
$ 23 .99 $23.99