Your cart is empty.
Your cart is empty.
Every Digital Thermostat Kit is run checked and tested at the factory to make sure that they meet quality control standards.
The TR-100 is a high performance upgrade and service replacement that is compatible with the entire line of Traeger grills (except the PTG, Ranger, and Scout).
Use the TR-100 as a performance upgrade or service replacement for the Traeger standard 3-speed or the Traeger digital thermostat.
Some of the Major Features of the Model TR-100 include the following:
- Three Digit Temperature Display
- Front Panel Cook Control
- Eight Cook Temperature Settings (180 to 375 degrees)
- High Cook Temperature Setting (up to 450 degrees)
- Front Panel Smoke Control
- Sixteen Smoke Settings (P0 - P5) for Precise Smoke Control
- Ignition Indicator
- Smoke Setting Indicator
- Cook Idle Fuel Rate Indicator
- Low Temperature Indicator
- Overtemperature Protection
- Low Temperature Overshoot Protection
- Cool Down Cycle
- One Year Manufacturer's Warranty
reb 77
2025-07-19 20:18:48
Worked perfectly and easy to install.
Andrew
2025-07-17 10:29:13
Ill start by responding to another review. The review said this was junk and the smoker was running super hot. They changed the P settings to no avail. Look, these are a cheap knockoff part. I wont argue that maybe they got a bad one. But mine is spot-freakin-on.I mention this because I almost didn't buy this controller because the review. I have this controller on a smoker I replaced and when my new-to-me smoker didn't have the digital display, nor did it have the auto shutdown feature, I wanted to get the controller I had experience with. My first cook on this new controller had me hyper focused on the temperature because the bad review. It fired off and shot right over my selected temperature, 10, 20, 25 degrees... ugh. They were right. I let it run. Using my fireboard my average temperature for 14 hours of cook time was 225 EXACTLY (my selected setting). I did bump the cook up to 250 so my average did rise, but I was shocked that it was able to keep the average so perfect. So to the angry person who said it couldn't maintain temperature, thank you for making me focus on the grill temp so I could be impressed at how well it did!
Jon
2025-07-07 10:45:39
Replaced my original Traeger controller with this upgraded one with temp prob and additional settings. Easy to install only took me about 15 minutes total. Works better than the original controller!
Chris W.
2025-04-11 11:10:15
Used this in a Traeger BBQ 070. Had to enlarge the hole it mounts in, used a dremel and file, once that was done I mounted the temp probe in the holes already drilled inside and ran the wires down under the hopper. I turned it on smoke and had the grill, drip pan and heat deflector removed. it started feeding pellets and smoking in about 2 minutes then I shut the lid and the temp took off like someone in another comment said. I opened the lid and started adjusted the "P" setting which didn't seem to do anything so I put it in shutdown and let it cool down and shut off. I put the heat deflector back in and put it to smoke again it started going what I thought was too high on smoke so I adjusted the "P" setting again. Originally it was on 1 so I put it on 4 and after about a minute or so the auger quit feeding pellets and the blower fan slowed down. It started working but was not hot enough so I switched it to 3 on the "P" setting and it started feeding more pellets and getting hotter, about 180 degrees on smoke, so I left it there and started adjusting it up in temp. I would let it go about 10 minutes at each setting all the way to high and it worked good. The temp was about 25-30 degrees higher than on the gauge on the lid which was good enough for me. Turned it to shutdown and let it go off, I really like this feature, it burns up the unused pellets in the pot and blows most of the ashes out of it too. I think the first time I adjusted the "P" function I did not wait long enough for it to adjust itself, also it may help to have the heat deflector installed too. The "P" function is adjusted by pushing the silver button by the display, if you push it once it shows the current setting and when you push it twice it moves to the next setting. Hopefully this will help someone else that has the temp going too high.
Papabear
2025-03-14 17:55:44
Works great, just like the original
Tom
2025-03-11 15:45:07
Product was great easy to install but did not solve my problem
Josh Rodriguez
2025-02-12 15:11:15
Didn’t last two smokes and is messing up. I had to replace the fuse after the first smoke. Tested all parts in the smoker and they are working as they should.
Dan
2024-12-22 17:11:09
Saved me from tossing the smoker
Recommended Products
$17.00
$ 8 .99 $8.99