Your cart is empty.
Your cart is empty.Niagara Conservation Toilet Handle And Pivot Clip, Use With Niagara Flapperless Toilets, Brand Niagara Country of Origin CHINA UNSPSC 31162801 UPC 732291221658 UPC Code 732291221658
Kirk005
2025-08-05 15:12:47
Pulled the old, broken parts out, installed these new ones. Simple, worked like a charm! One bonus, the old flush handle was white plastic….the new one is chromed plastic. Fancy!
W. ANDERSON
2025-07-25 12:45:16
While visiting my in-laws I was able to order the part and install it. Works better than the old handle that was missing because it slipped of the handle shaft. The new one snapped in place and stays put. A trick for easy removal of the old pivots is to use the new ones like wedges on the pivot on the handle side to release the water tray. You will of course have to turn the water off and remove the water line in the tank by undoing the two fittings on the line on the bottom of the toilet tank first. Then lift the handle side of the tray and tip it up out of the other pivot, Simple process, but there should have been some directions included showing how to do it.The flush is very marginal, the water level needs to be adjusted to the very top of the water tray for a proper flush. On ours the screw on the float adjustment was not enough. I bent the water line towards the handle side a bit which raised the float higher. That did the trick and the toilet actually flushes now, made a real difference. Otherwise my in-laws were going to replace the toilet. Had to set the water level to within an eight inch of the top edge of the tray.
Steven Kimbrell
2025-05-18 14:33:22
as described
Customer
2025-05-05 09:08:47
Perfect fit and super fast delivery. It was a very easy install and quality product.Did not have a problem with the handle like some reviewers had clipping it on.Highly recommend it to anyone with a Niagara Conservation N2216T Flapperless Toilet.
wisconsin437
2025-04-30 14:38:34
To the reviewers that say the handle doesn't stay on, you have to give it a good push and it will snap into place. It has a detent to hold it in if you look at the inside of the handle.
Fred
2025-03-26 18:29:25
My handle broke (split apart) after a few years' use. Used only the handle from this kit. It snapped onto the tipper without needing to replace any other parts and works fine (had been using a small vise grip until I bought this).
elderly
2025-03-08 12:33:54
Works great! Obscure toilet hardware, hard to find. worked great
Tim
2025-01-16 17:09:21
Everything went together very easily. Except the handle did not stay on. It needed to be glued on. Too bad. Get what you pay for.
Recommended Products
