Your cart is empty.
Your cart is empty.Product Description
About KooMall
KooMall is a brand focused on producing anti-static products. We can not only protect your electronic components from static damage, but also protect your harm from static electricity
INSTRUCTION
The plug fits directly in to the mains supply socket, connecting with only the earth conductor. Live and Neutral pins have been molded in insulating plastic, fitting into the supply socket but completely dormant.
The 1M Ohm resistor to each connector offer protection in the event the workstation becomes live. That protection would limit the current to less than 0.3mA at 240 volts. Should the fault current continue the resistor will open circuit.
IInsert the plug into the supply socket making sure it is fully home, then connect the various elements of the EPA...such as ESD wrist strap,ESD Mat, Grounding Cord,Equipment and so on. This ensures that the EPA is at the same earth potential. As generally the workstation has more than one plug socket it is possible to use more than one EBP if more connections are required
The EBP is sealed and cannot be opened for repair. To test each connection use a multi-meter from the connector to the earth pin. The reading should be between 0.9 and 1.1M Ohms. As each connection point has its own 1M Ohm resistor, the resistance between two connectors should be approximately 2M Ohms. All EBP's are tested and then packed.
Applications
Work with Wrist strap
Work with ESD Mat
Work with Equipment
How To Test The Conductivity
KooMall ESD kit system resistant is 1-3M Ohms. There is 1M Ohms Safety Resistor in each grounding part. That is, there is 1M ohms in ESD Plug, ESD Wrist Strap Coiled Cord and Grounding Cord. So, when you test any part of conductivity by multimeter. You need to choose the right channel which resistance is more than 2M Ohms. Otherwise, there is not any value in multimeter.
Protazoid
2025-09-03 10:02:59
Simple ESD bracelet works as expected.Ignore the reviews about no conductivity, there is a 1M ohm resistor in series. This is to protect against devices that have a lot of charge on them and discharge when you touch it. This is normal.This isn’t a personal safety device. It’s to protect electronics when working on them.
RICARDO ESCOBAR
2025-08-23 13:43:35
Se me quitó el dolor del nervio ciático
Jerma Panda
2025-06-30 21:18:16
Super functional for applications where static charge could damage electronic components. It’s a compact affordable and easy to install and easy to maintain. The wristband and the locking measures didn’t appeal to me so I ordered a different one and was able to use it for a grounding on the table.
C.joseph
2025-04-05 17:52:20
Waiting for meter to check to see if if it's working properly
Ivan A.
2025-03-30 13:19:58
Purchased 2 units of this product. Mat to Plug cords are conducting ok. Though both have bad wrist band cords - no conductivity between cord ends. Making whole product useless and dangerous, considering the fact that it's a safety device.
GG
2025-03-16 12:54:52
There is zero continuity between the connections on both wires and the three connections on the plug. Now I have to waste my time driving to Kohl's to return this POJ. Look elsewhere
simon cortez
2025-02-18 18:49:41
Bought these to use for earthing. Tested it but no grounding signal. Waste of money.
Long V Nguyen
2024-12-21 11:45:08
Open circuits in everything, even in the cable.
Recommended Products